EasyManuals Logo

Dynacraft MY LITTLE PONY 4x4 User Manual

Dynacraft MY LITTLE PONY 4x4
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
TROUBLESHOOTING GUIDE
Problem
Vehicle does not run
Vehicle was running
but suddenly stopped
Possible Cause
Undercharged battery
Tripped thermal fuse
Electrical switch damage
Dead battery
Motor damage
Loose wires or connectors
Solution
Charge the battery. A new battery should
have been charged for at least 18 hours
before using the vehicle for the rst time.
After rst-time use, recharge the battery
for at least 12 hours after each use. Never
charge the battery longer than 30 hours.
Check all connectors. Make sure the batte
ry
connector is tightly plugged into the charger
connector, and that the charger is plugged
into the wall outlet.
Make sure that there is power ow to the
wall outlet.
The built-in thermal fuse may “trip” and shut
down operation of the vehicle if the vehicle
is overloaded or the driving conditions too
severe. O eht tes,deppirt sah esuf a ecn
2 minutes before operating the vehicle again.
To avoid repeated automatic shutdowns,
do not overload the vehicle by exceeding
the 65 I
bs maximum weight capacity or by
towing anything behind the vehicle. Do not
drive up hills or run into xed objects, which
can cause the wheels to stop spinning while
power is still being supplied to the motors.
The electrical switches can become corroded
due to exposure to water
or moisture, or can
jam due to loose dirt, sand or gravel.
Check all wires and connectors. Make sure
the battery connector is tightly plugged into
the control module connector and that there
are no
loose wires around the
motor.
If your battery is old or if you have not
followed Battery Care instructions, your
battery may be dead. “Replace only
with an original 6 Volt (7.0 Amp/Hr.) battery
with built-in thermal fuse. Do not use non-
original substitute parts.
Visit the Dynacraft website and replace with
a new motor.
Check all wires and connectors. Make sure
the battery connector is tightly plugged into
the control module connector, and that there
are no loose wires around the motors.
23
power switch to the "OFF" position, release
the foot pedal, and wait approximately

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynacraft MY LITTLE PONY 4x4 and is the answer not in the manual?

Dynacraft MY LITTLE PONY 4x4 Specifications

General IconGeneral
BrandDynacraft
ModelMY LITTLE PONY 4x4
CategoryMotorized Toy Car
LanguageEnglish

Related product manuals