EasyManuals Logo

Dynalite DMC810GL User Manual

Dynalite DMC810GL
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
preset programming using the program key
………………………………………………………………………………………………………....
………………………………………………………………………………………………………....
DMC810GL Instruction Manual Rev B.DOC 7
AUX Input - This is a dry contact interface that is active low. The dry contact is connected between the AUX
and GND terminals on the DyNet connector strip. The function of the AUX input is programmable. Ensure
that the cable length between the dry contact and terminal strip is no longer than 2 metres.
Service LED - The Service LED has 3 signalling modes, which are useful for troubleshooting:
Blinking slowly (1Hz) = Normal Operation
Blinking fast (4Hz) = Network Activity Detected
On = Fault
Service Switch - The Service Switch has three functions:
1 push = Transmit Network ID
3 pushes = All Channels 100%
Push & hold for 4 sec = Reboot
Top Set - This adjusts the maximum output that all other control sources can select, ie: if the Top Set is fully
clockwise, 100% selected by a control source will give 100% output. If it is fully anti-clockwise, 100%
selected by a control source will give 50% output. This control is useful for extending lamp life and can be
operated without any form of network control, effectively turning the device into a stand-alone power
conditioner and lamp protector.
Accessory Module Socket - Accepts plug in multi function accessory modules for optional features such as
additional dry contact inputs, 2
nd
DyNet port and Time clocks. Consult your distributor for details on the
available accessory modules.
dimmable lamps chart
………………………………………………………………………………………………………....
INCANDESCENT
LAMPS
Incandescent lamps are easily dimmed using all Dynalite controllers. The soft start and
voltage limit features will extend lamp life. Lamp life can be further extended using the
voltage limit adjustment.
TUNGSTEN
HALOGEN
LAMPS
Tungsten halogen and other transformer loads are easily dimmed using all Dynalite
controllers. The soft start and surge limiting features will protect lamps against premature
failure. Lamp life can be extended using the voltage limit adjustment. Ensure that
transformer is designed for dimming.
FLUORESCENT
LAMPS (26mm,
T8)
26mm slimline tubes can be dimmed to as low as 1% using a dimmable electronic ballast.
No de-rating is necessary with electronic ballasts. Contact your Dynalite dealer for more
information.
FLUORESCENT
LAMPS (16mm,
T5)
16mm slimline tubes can be dimmed to as low as 1% using a dimmable electronic ballast.
No de-rating is necessary with electronic ballasts. Contact your Dynalite dealer for more
information. Must be dimmed with electronic ballasts which accept 1-10V, DSI or DALI
broadcast.
COMPACT
FLUORESCENTS
Only some types of CFL lamps can be successfully dimmed. Best results are achieved with
dimmable HF ballasts

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynalite DMC810GL and is the answer not in the manual?

Dynalite DMC810GL Specifications

General IconGeneral
BrandDynalite
ModelDMC810GL
CategoryController
LanguageEnglish