hold down programming of presets
………………………………………………………………………………………………………....
………………………………………………………………………………………………………....
DMC810GL Instruction Manual Rev B.DOC 9
STEP 1:
To program preset scenes, press MANUAL
STEP 2:
Adjust channel levels using sliders.
STEP 3:
Press and hold down the button to which the settings are
to be stored for at least 5 seconds. Repeat this process
for the other presets. The preset scenes are now stored
and can be recalled by pressing the relevant buttons on
this panel, or other panels in the same area.
one touch button operation
………………………………………………………………………………………………………....
STEP 1:
With a simple button push you can toggle between on and off.
STEP 2:
By holding your finger on the button you can raise and lower the
lighting circuit or circuits that are connected to the button. To
alternate between up and down stop pushing for a moment and
then hold down again. The level that is selected is saved and
restored when the lights off and then on again.