Dynamic DX2-REM551

GBK60348: Issue 3 21
DX Mode (for the CLAM/TAM)
Functions F1 - F5 operate actuators 1 - 5. Function F9 operates actuators 3 + 4 simultaneously.
Only the actuators that have been enabled are shown in the menu. If actuator 3 and 4 are
both enabled, function 9 is added to the menu automatically.
2.5.5 Lighting Mode – Standard
The lighting menu is available when:
 the CLAM Lighting Enable parameter (see DSM section 6.6.2.1) has the value
'Yes';
 a CLAM or lighting module is detected in the system;
 the Lighting Menu parameter (4.2.1.8) is set to 'Yes'.
Deflect the joystick to turn the associated light on or off.
Button
Function
Left Indicator
>2s: Side lights
Right Indicator
>2s: Hazard lights
Not active
Lighting Mode Menu Map
Rotate the orientation of
the joystick with Accessory
Menu Navigation (4.2.1.6).
Side
Lights
Hazard
Lights
Left
Indicator
Right
Indicator
Next
Acc
Prev .
Acc
Drive
The function keys are not active in this mode.
Left
Indicator
Previous
Accessory
Hazard
Lights
Next
Accessory
Right
Indicator
Side
Lights