Need help?Do you have a question about the Dynamic RHINO2 DS160 and is the answer not in the manual?
General| Input Frequency | Up to 200 kHz |
|---|---|
| Type | Digital Stepper Motor Controller |
| Output Current | 6.0 A |
| Protection | Over Voltage, Over Current, Short Circuit |
| Operating Temperature | 0 - 50°C |
| Communication | RS485 |
| Model | Dynamic RHINO2 DS160 |
General recommendations and best practices for wiring the controller.
Details on connecting the battery, including wire gauge and connectors.
Instructions for connecting the motor to the controller, including wire gauge.
Step-by-step procedure for testing the installed system.
Using the HHP for parameter adjustment and diagnostics.
Using PC software for advanced diagnostics and configuration.
Comprehensive list of adjustable parameters and their settings.
Detailed explanations of each programmable parameter.
Configuring throttle type, input, calibration, and response.
Adjusting speed, acceleration, and deceleration for optimal drive.
To Next Page
