OPERATING THE DIESEL GENERATOR
2-4.2 Remote starting
There are ON OFF, Preheat ( ) and Stop Preheat ( ) buttons in Remote
Starter Key. Your remote start unit (with 8 wires on) has remote glow plug
function, the operating procedures are as follows:
1. Please refer to above generator operation instruction for start using
electronic key;
2. If you want to use remote start, please make sure that your electronic key
switch is put on "ON" position;
3. Press the ON button to start the genset, and press the OFF button to stop the
genset;
4. If you use electronic key to start the generator and then use Remote Starter
Key to shut it down, make sure that you need turn electronic key switch to OFF
position; otherwise, your generator battery will drain charge gradually;
5. In case your remote control unit fails and a remote jumper comes with your
user's manual package, please unplug your remote control unit first, then plug
the remote jumper; this will enable you to use electronic key to start your
generator; if there is no remote jumper with your package, please follow the
order shown in the picture of remote jumper to electrically shorten the two
corresponding wires coming out of your control unit, then you shall us e
electronic key to start your generator.
2-4.3 Battery
NOTE:
If you crank the starter too long, the battery may be drained too much to
provide enough energy for proper engine ignition.
Also, when the diesel engine is operating, let the electronic key remain in
the "ON" position.
13
Fig 11 Remote starter and remote jumper
Preheat
1
Remote Jumper
Remote Starter
Signal Receiver
To Next Page
Loading...