EasyManua.ls Logo

Dynamo Power DP7100 - Using the Glow Plug

Default Icon
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATING THE DIESEL GENERATOR
IMPORTANT NOTE
2-5 How to use glow plug
Fig 12 Control panel with preheater knob
Diesel generator will be very hard to start in cold winter. However, glow plug
will help start dies& generator much easier. Please turn electronic key
counterclockwise to HEAT position and hold about 10 seconds to preheat cold. If
your diesel generator comes with 8-wire remote control unit (it needs special
order, extra charge applies), you can remote control glow plug. The operating
procedures are as follows:
ON and OFF buttons used for remote starting engine; Preheat ( ) and Stop
Preheat ( ) buttons used for controlling glow plug respectively (see Fig 11).
They are interlocked with each other and only one set works at a time, preheat
set is programmed for powering on glow plug 10 seconds and you can press
the( ) button for power off also glow plug will automatically power off after 20
seconds.
Some of our units come with a dry battery for shipping safety purposes. In
order to get your generator started for the first time, the battery must be filled
with battery acid which can be purchased at a local automotive supply store
and slowly charged (trickle charged) for a day. After charging, the battery
may be used.
,