P/N 35 84 70
W-1012-2EN Hydr Propulsion Pumps CC 102/102C/122/122C 7
General
Reassembly
Reassembly
1. Use only genuine spare parts. We recommend the use of pre-assembled,
coordinated and tested component groups. The required component groups
and seal kits should be selected from the spares list and ordered by quoting
the code plate details.
2. Assembly should be carried out observing the maximum cleanliness.
3. Assembly is carried out in reverse order to dismantling unless otherwise
stated, e.g. Bearings in Front Case to be pre-loaded.
4. Fundamentally do not reuse old seals.
5. Oil components before assembly (hydraulic mineral oil).
6. Tighten screws with torque wrench according to specifications. If there is any
suspicion of stripping of threads, use new screws.
7. When carrying out dismantling/reassemble instructions refer to the
appropriate drawings.
Important
On completion of repair, close all openings with plugs. Should difficulties
arise, please contact our nearest service centre.
To Next Page
Loading...
