6. Position switch 2: boundary filters
7. Analogue input sensitivity: sets the maximum input voltage
8. SPL level: sets the SPL for -6 dBFS (-6 dB from selected maximum input voltage)
9. AC power Input (100-240 V)
10. Analogue in: Balanced analogue input (XLR)
11. Digital In: AES digital input (XLR)
12. Digital Out: AES digital output – pass through for second monitor (XLR)
13. Word Clock: Word Clock input (75 Ω BNC)
14. Service: USB Type B for firmware update or service
Figure 2: Core Sub Controls
1. Power mode: Power-saving auto-standby switch
2. Bandwidth: sets a Linkwitz-Riley LPF at 80 Hz
3. Position switch 1: position filters
4. Position switch 2: boundary filters
8 Core User manual
To Next Page
Loading...
