Placement
Power to speakers
Connect speakers
Select INPUT or
DIRECT In
Unpack the speakers and
place them in the room.
Connect power to the speakers,
using the power cable and by
turning the switch to “I”.
Connect source outputs to inputs
on speakers.
Switch to master and slave.
For support of resolution up to
24bit/192kHz, a coax cable connection
must be applied between master digital
output and slave digital input.
Point the remote towards
the speaker and select INPUT
or DIRECT In.
Subject to change without notice.
Please note that the latest version of this manual is available on dynaudio.com
Do you have questions or want to give your feedback?
Please visit dynaudio.com/support
First time
Setup
Enjoy the crystal
clear sound
Focus XD
1
2
3
4
3816_DYN_Focus_XD_Setup_V2.indd 1 15/12/2016 11.31
To Next Page
Need help?
General
