Need help?Do you have a question about the Dynaudio Focus XD and is the answer not in the manual?
General| Resolution | 24-bit/192kHz |
|---|---|
| Type | Active loudspeaker |
| Frequency Response | 20Hz - 24kHz |
| Wireless Connectivity | Bluetooth |
| Inputs | Analog RCA, Digital (RCA) |
| Tweeter | 28 mm soft dome |
| Woofer | 18cm MSP |
Warnings about electrical hazards within the loudspeaker housing.
Caution regarding potential hearing damage from loud audio.
Explanation of symbols and terminology used in the manual.
Steps for unpacking and checking the loudspeaker system for damage.
Guidance on reusing packaging for future transport.
Information on environmentally friendly disposal of electronic equipment.
Warning about sharp spikes and protecting surfaces during setup.
Advice on placement regarding light, heat, and electromagnetic fields.
Instructions for setting up floor-standing models with base and spikes.
Recommendations for positioning compact models on stands or shelves.
Guidelines for choosing the best room placement for sound quality.
Differentiating between left and right speaker units.
Recommended minimum distances from walls to avoid sound degradation.
Optimal distances for creating an equilateral triangle setup.
Angling speakers towards the listening area for improved imaging.
Instructions for fitting and removing the protective speaker grilles.
Connecting digital and analog audio sources to the loudspeakers.
Location of the service port for firmware updates.
Adjusting sound characteristics via rear panel controls.
Configuring master/slave roles and audio zones.
Connecting the loudspeaker to the power supply.
Overview of buttons for volume, input, mute, power, and hub selection.
Details various methods for digital signal connection.
Wired connection setup for stereo pairs.
Setup for a single wired loudspeaker with wireless link to another.
Connecting loudspeakers wirelessly using Dynaudio Hub or Connect.
How to connect analog audio sources to the loudspeakers.
Using loudspeakers with external volume control (External mode).
Using the Speaker Position knob to tune bass response.
Using the Treble switch to alter high-frequency sound.
Connecting the power cable and verifying voltage compatibility.
How to turn speakers on, off, and put them into standby.
Choosing between analog, digital, or Hub/Connect inputs.
Controlling the loudspeaker volume using the remote.
Temporarily silencing the audio output.
Description of the top-edge display and its functions.
Blue/Violet for on-state, dim red for standby.
Red flashing LED for no active Hub or Connect.
Sequential LED illumination/extinguishing during power states.
Flashing LEDs indicating digital or analog input selection.
Flashing LEDs showing selected Hub A, B, or C.
Flashing LEDs indicating selected input 1, 2, 3, or 4.
Blue LED flashing and white LEDs moving for input searching.
Step-by-step guide for updating the loudspeaker firmware via USB.
Detailed technical specifications for the Focus XD series.
Guidelines for cleaning the loudspeakers safely and effectively.
Information on warranty coverage and registration.
Advice on handling malfunctions and seeking assistance.
To Next Page
