Dynisco 1392 Series - Page 40

40
Jbus MODbus Description Display Attribute
Address Address Code
259 258 Decimal point position R
Range:
0 = No decimal figure
1 = One decimal figure
2 = Two decimal figures
3 = Three decimal figures
4 = Four decimal figures
Note: Decimal figure assigned to:
- Initial scale readout
- Final scale readout
- Input variable without filter
- Filtered input variable
- Peak max value
- Peak min value
- Full scale transducer calibration value
- Tare calibration value
- Alarm 1 threshold
- Alarm 2 threshold
260 259 Initial scale readout RDM
261 260 Final scale readout RDM (“F.S.U.”) RDM
263 262 Multiplier R
Range: 1 - 10 - 100
Note: Multiplier assigned to:
- Initial scale readout
- Final scale readout
- Input variable without filter
- Filtered input variable
- Peak max value
- Peak min value
- Full scale transducer calibration value
- Tare calibration value
- Alarm 1 threshold
- Alarm 2 threshold
264 263 Display filter time constant (“F.t.C.”) R
Range:
1 = 400 ms filter time constant
2 = 1 s filter time constant
3 = 2 s filter time constant
4 = 3 s filter time constant
5 = 4 s filter time constant
6 = 5 s filter time constant
46