Dynisco ATC770-0-2-3 - Page 79

ATC770 Microprocessor-Based Pressure/Process Controller 79
Range: Use ▲ and ▼ keys to switch the upper display from OFF to On 4, then press FUNC
key to load the default data of the parameters belonging to group 1, group 2, group
3 and group 4.
11.5 GROUP 5 PARAMETERS
PRESSURE INPUT SELECTION - Group 5
Available: Always.
Upper display: Type of pressure input selection.
Lower display: PI.TYP
Range: Str, 0-20, 4-20, 0-5, 0-10. Strain gage, 0-20 mA, 4-20 mA, 0-5V, 0-10V
Default value: Strain gage.
NOTE: Remember to make the proper selection of internal jumpers.
REMOTE SET POINT INPUT SELECTION - Group 5
Available: Only if remote set point input circuit is fitted.
Upper display: Type of remote set point input circuit is fitted.
Lower display: RI.TYP
Range: OFF, 0-20, 4-20, 0-10. Disabled, 0-20 mA, 4-20 mA, 0-10V.
Default value: 4-20 mA.
NOTE: Remember to make the proper selection of internal jumpers.
CONTROL OUTPUT SELECTION - Group 5
Available: Always.
Upper display: Type of control output selection.
Lower display: CO.TYP
Range: 0-20, 4-20, 0-10, -10-10, 0-5. 0-20 mA, 4-20 mA, 0-10V, -10-10V, 0-5V
Default value: 0-10V.
NOTE: Remember to make the proper selection of internal jumpers.
RETRANSMISSION OUTPUT SELECTION - Group 5
Available: Only if retransmission output circuit is fitted.
Upper display: Type of retransmission output selection.
Lower display: OFF, 0-20, 4-20, 0-10, -10-10, 0-5. Disabled, 0-20 mA, 4-20 mA, 0-10V, -10-10V,
0-5V.
Default value: 0-10V.
NOTE: Remember to make the proper selection of internal jumpers.