Dynon Avionics SkyView HDX - 1. Introduction; Before You Fly; Warning; Video Training

HDX Autopilot Servo Installation & Maintenance Manual - Piper PA-34 Seneca Series, Rev A
Page | 5
1.4 Manual Iconography
This manual uses the following iconography:
Alerts reader to critical guidance that if not followed could result in an unsafe
condition.
Alerts reader to FAA regulatory information.
Alerts reader to important installation and/or maintenance information.
Alerts reader to helpful tips or suggestions.
1.5 Referenced Documents
The following Dynon Avionics documents are referenced in this manual:
• 103261-000 SkyView HDX System Installation Manual
• 103947-000 SkyView HDX Wiring Diagram - Twin Engine
• 103777-000 SkyView HDX System Equipment Installation Record
• 103000-000 Dynon Servo Shear Screw Replacement Kit Instructions
1.6 Mechanical Drawings
All mechanical drawings included in this manual are for reference purposes only. They should
not be scaled or copied and used as templates or patterns.
1.7 Installation Record
The mechanic or facility performing the installation should record where each SkyView Autopilot
component has been installed in the airplane. This documentation should be entered into
airplane’s permanent record. Dynon provides a document template to record this information.
Download the SkyView HDX Equipment Installation Record document at
www.dynon.aero/stcdocs.