Dyson Airblade - Installation Procedures; Electrical requirements

Dyson Airblade
TM
hand dryer
5
Electrical requirements
Installation Procedures
Check that the electrical supply
will correspond with the rating
plate located on the lower left
side of the unit.
If the unit is connected to any
electrical supply other than what
is stated on the rating plate of the
unit, permanent damage or
improper/unsafe operation of the
Airblade
TM
hand dryer may result.
A means for all pole disconnection
must be incorporated in the fixed
wiring to the appliance in
accordance with local wiring
regulations.
Installation work and electrical
wiring must be done by qualified
person(s) in accordance with all
federal, state and local applicable
codes and standards, including
fire-rated construction.
The Dyson Airblade
TM
hand dryer requires:
A separate or dedicated circuit
A minimum 15 amp time delay
fuse or circuit breaker
If you have any questions
on the installation please
call our Dyson Helpline toll
free at 1-888-DYSON-AB
ENG