Remove the cover and brush bar
Look for obstructions
Remove the Hair screw tool from the wand or machine.
Push the base plate open. Press the red lever down to release the
cleaner head cover.
Pull the cleaner head cover off the main body of the tool.
Put your brush bar back into position and press firmly until it clicks back
into position.
Check the red locking lever is in the unlocked position. Align the cleaner
head cover with the guide on the main body. Push it down until it clicks into
position.
Push the red locking lever up until it clicks into position and push the base
plate back into place.
Clearing blockages from your
Hair screw tool
Your Hair screw tool doesn’t have a washable brush bar. To maintain optimum
performance, check your brush bar regularly and clear any obstructions.
Make sure your machine is disconnected from the charger and your machine
power is turned off.
Don’t put any part of your machine in a dishwasher or use detergents, polishes
or air fresheners.
Pull your brush bar firmly to remove it from the main body.
Check and remove any obstructions from all three parts of your
Hair screw tool.
Your Hair screw tool isn’t washable. Wipe over with a damp lint-free cloth.
Re–assemble the Hair screw tool
Slide the housing
back on to the
brush bar and
push the lever on
the back of the
Hair screw tool
upwards to lock.
The location of the
lever to release the
brush bar is located
at the back of the
Hair screw tool.
To Next Page
Loading...
