Charging your machine
Changing your click-in battery
For the best experience, we recommend fully charging your machine, and
any additional batteries, as soon as you open the box and after every clean.
If you have additional click-in batteries, we recommend that you alternate the
batteries to maintain even performance.
Refitting your battery
Removing your battery
Align your battery with the handle and slide it in.
Push firmly until it clicks into place.
Push the Battery release button on the handle and slide the battery off
your machine.
Charge the battery.
The LED light on the end of the handle will flash when the power is running
low and you need to put your battery on to charge.
Connect the charger directly to the charging point on the base of the
handle of your machine. You can also connect to your dock as shown in the
installation instructions supplied with your dock.
The LED light on the end of the handle will pulse with a blue LED light when
charging, and the light will go out when fully charged.
It can take up to four hours to fully charge your battery. Your battery has
been designed to be left on charge.
Your machine won’t operate or charge if the ambient temperature is below
5°C (41°F). This is designed to protect both the motor and battery.
You can help prolong the battery life by leaving your machine to cool down
before recharging.
The button on the end of the
handle is pushed upwards to
release the battery in the handle.
The charger connected from
the power supply directly into
the base of the handle.
To Next Page
Loading...
