Washing your filter
Wash your filter at least once a month to maintain the best performance.
Make sure the filter is completely dry before refitting.
Twist off your filter
Wash your filter
Shake and dry
Refit your filter
To refit your filter, slide it onto the handle and turn it clockwise until it clicks into place.
Your filter may need more frequent washing if you vacuum fine dust, use Max mode
frequently or use with the bin full.
Don’t put any part of your machine in a dishwasher or use detergents, polishes or air
fresheners.
Turn your filter anti-clockwise and pull it away from your machine.
Before washing your filter, tap it gently over a bin to remove any loose dust and debris.
Wash the outside of the filter, rubbing with your fingers to remove the dirt.
Carefully rinse the inside filter, without allowing water to fill the filter.
Repeat these steps until the water runs clear.
Empty the filter and shake firmly to remove excess water.
Keep shaking until there’s no water coming from the filter.
Place your filter end up, as shown.
Leave your filter to dry for at least 24 hours in a well-ventilated, warm place.
Don’t dry your filter in a tumble dryer, microwave or near a naked flame.
Important: your filter must be completely dry before you put it back into the machine.
Your machine could be damaged if used with a damp filter.
Filter held in upright position, with the wider
end in the palm of a hand. Water running
from a tap into the narrower end.
Filter with hand over
the open end with
arrows showing a
shaking motion.
The filter is left to dry with the
pleated filter end facing upwards.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
