Dyson Purifier Humidify+Cool User Manual

Filling the water tank
Before you remove the water tank, make sure humidification modes are
turned off and the water tank is empty.
Keep the cap dry
Keep the cap on the water tank dry when you run a Deep clean cycle or fill
the tank. It contains power connections and should not be washed. If wet,
wipe thoroughly with a dry cloth. Make sure the cap and connections are
completely dry before refitting.
Remove the tank
Push down the Water tank release buttons on the sides of your machine.
Slide the water tank out of your machine.
Carry the water tank by its handle to the tap, and unclip the cap.
Fill the tank
MAX level
Fill the water tank to the Max level with cold tap water.
Replace the tank
Replace the cap and secure the cap clips in place.
Make sure the cap is completely dry. If wet, wipe thoroughly with a dry cloth.
Slide the water tank back into your machine until it clicks securely in place.
The water tank cap has two lips either side that
can be pulled upwards to release the cap.

Dyson Purifier Humidify+Cool Specifications

General

Package width	350 mm
Package height	1000 mm
Package weight	12120 g
Filter life (max)	12 month(s)
AC input voltage	240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	43.4 W
Display type	LCD
Product color	Silver, White
Housing material	Acrylonitrile butadiene styrene (ABS)
Airflow	43.5 l/s
Noise level	62.4 dB
Air purify rate	- m³/h
Number of speeds	10
Country of origin	Malaysia
Oscillation angle	90 °
Suitable for room area up to	- m²
Suitable for room volume up to	81 m³
Harmonized System (HS) code	8421392590

Weight and Dimensions

Depth	312 mm
Width	220 mm
Height	923 mm
Weight	8050 g