Dyson V12 Detect Slim User Manual

Dry your filter
Leave your filter to dry for at least 24 hours in a well-ventilated, warm place.
Don’t dry your filter in a tumble dryer, microwave or near a naked flame.
Important: your filter must be completely dry before you put it back into the machine. Your machine could be damaged if used with a damp filter.
Washing your Laser Slim Fluffy™ brush bar
Your Laser Slim Fluffy™ cleaner head has a washable brush bar. To maintain optimum performance, check and wash your brush bar regularly.
Make sure your machine is disconnected from the charger and take care not to touch the trigger.
Remove your brush bar
Don’t put any part of your machine in a dishwasher or use detergents, polishes or air fresheners.
Press the cleaner head release button on the end of the wand. Place the cleaner head upside down.
Push the end cap up fully and pull the brush bar out of the cleaner head.
Wash and dry your brush bar
Hold your brush bar under running water and gently rub to remove any lint or dirt.
Stand your brush bar upright as shown. Leave to dry completely for at least 24 hours.
Replace your brush bar
Before replacing, check that your brush bar is completely dry.
Reattach the end cap to your brush bar.
Slide your brush bar into the cleaner head. Push the end cap back down to the closed position.

Dyson V12 Detect Slim Specifications

General

Turbo	Yes
Cleaning type	Dry
Cleaning surfaces	Carpet, Hard floor
Number of settings	3
Vacuum air filtering	-
Dirt separating method	Cyclonic
Color name	Sprayed Gloss Gold /Gloss Gold
Display type	LED
Product color	Gold
Dust container type	Bagless
Power source	Battery
Charging time	4 h
Suction power	150 AW
Battery voltage	- V
Package depth	154 mm
Package width	806 mm
Package height	271 mm
Package weight	5580 g
Vacuum brushes included	Motorized brush

Weight and Dimensions

Depth	252 mm
Width	250 mm
Height	Blablabla mm
Weight	2400 g