Need help?Do you have a question about the e-motion nGauge and is the answer not in the manual?
General| Voltage Range | ±10 V |
|---|---|
| Analog Inputs | 8 |
| Digital Inputs | 4 |
| Communication | USB |
| Measurement Parameters | Voltage, current, temperature |
| Current Range | ±20 mA |
| Accuracy | ±0.1% FS |
States E-Motion's limited responsibility regarding product use, installation, and serviceability.
Warns about obstructing driver view, interfering with controls, and adhering to state laws for windshield mounts.
Alerts Onstar subscribers to potential diagnostic service interruptions when using OBD II devices.
Provides tips and warnings for routing the nGauge OBD II cable to ensure safe vehicle operation.
Advises on optimal placement for the windshield mount to avoid obstructing the driver's view.
Explains the correct procedure for inserting and removing the SD memory card from the nGauge.
Describes how to navigate through the nGauge interface using the [V] and [x] buttons.
Details the steps to connect the nGauge to a vehicle and find available signals.
Guides users on how to switch between different gauge display layouts.
Details the process of selecting and assigning a vehicle signal to a specific gauge display.
Explains how to modify a gauge's display attributes like name, unit, color, or range.
Instructs on setting low and high warning thresholds for gauges, with color-coded alerts.
Covers setting minimum, maximum values, and scaling options for round gauge displays.
Describes how to use the nGauge to monitor and log vehicle data.
Explains how to connect and integrate Zeitronix wideband products with the nGauge.
Details how to start, stop, and view logged data files saved on the SD card.
Step-by-step instructions for reading vehicle diagnostic codes and clearing them.
Instructions for updating the nGauge firmware using an SD card.
Guide for updating the nGauge firmware via a USB connection to a computer.
How to switch between standard and metric units for displayed signals.
Procedure for adjusting the screen brightness level of the nGauge.
Setting the screen that appears automatically when the nGauge is powered on.
Configuration of events that trigger the nGauge's sleep and wake modes.
Instructions for restoring the nGauge settings to their factory defaults.
Steps to calibrate the touchscreen for accurate input response.
Explains how to connect analog input signals to the nGauge's analog ports.
Guides on setting up drivers for analog inputs, including linear and non-linear conversions.
Covers setting correction factors and offsets for linear analog sensor inputs.
Explains how to convert raw analog voltage signals into meaningful physical units.
Procedure for updating firmware on nGauge units with version 120 or later.
Instructions for updating firmware on nGauge units with version 119 or earlier.
Diagrams and information on the pin configuration of accessory cables for the nGauge.
To Next Page