EasyManuals Logo

Eachine E180 User Manual

Eachine E180
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
2
The helicopter has no response after
connecting batteries to receiver.
Check whether the transmitter and
receiver connecting to power; check the
voltage of transmitter and receiver; Battery
pole flake contact is not good.
Open the transmitter, make sure the
batteries connecting is good Replace and
charge transmitter batteries Make sure the
battery pole flake contact is good.
3
When push the throttle pole, the rotor do
not rotate and the LED on Receiver
flashes cons tantly.
Low battery voltage; batteries connection
is not good.
Replace and charge the batteries, reconnect
the batteries to the receiver board.
4
Helicopter takes off immediately, once
the batteries and receiver connected.
Didn’t put the throttle to the lowest
Put the throttle pole at the lowest position
before open the transmitter.
5 Helicopter vibrates or shakes in flight.
Damaged frotor blades and lateral axis
blade grips too tight causing the
movement of the main rotor isn’t smooth.
Change the main rotor blades, and lateral
axis Loosen the blade grips properly.
6 Main rotor blades are shaking in flying.
Lateral axis is bent Latreral axis screw is
not tight .There are some debris in the
servo, causing shakes .
The loose between the swashplates.
Deformed or damaged t ail rotor blades.
Replace the lateral axis. Tighten the lateral
axis screw. Change the Bearing.
Remove the servo, and clear debris.
Compress the swash plates. change the tail
rotor blades.
7
The sound of the main rotor becomes
smaller.
Low battery voltage of helicopter.
Charge the battery or change a fully charged
battery.
8
Helicopter has no reaction or can not fly
smoothly.
Failure of binding
Rebind the helicopter and transmitter,
make sure you place the helicopter static
level next to the transmitter.
9
3D/6G model helicopter appeared yaw
Swashplate servos not back in to mid-
position or damage
Length adjustment rod, so that the vertical
spindle swashplate Replace the servo
10 Helicopter yaw occurs in 6G mode, Helicopters hover need to reconfigure Reference helicopter 6G mode setting

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eachine E180 and is the answer not in the manual?

Eachine E180 Specifications

General IconGeneral
BrandEachine
ModelE180
CategoryToy
LanguageEnglish

Related product manuals