Why does my Eagle Gate Opener stop and reverse?
Your Eagle Gate Opener might be stopping and reversing due to several reasons: * The gate operator may not be plumb and level, in which case you should remount the operator or swing arm. * The ERD current sensor might be set too sensitively; try turning the ERD sensor slightly clockwise. * The gate may have encountered an obstruction during travel. Check for and remove any obstructions.
What to do if my Eagle Gate Opener won't close?
If your Eagle Gate Opener won't close, here are a few things to check: 1. If the Radio Receiver's LED remains on, the remote or receiver may have malfunctioned in the 'on' position. 2. If one or more of the global input LEDs remain active, check any Global Inputs for a possible short circuit. 3. If the gate reopened because it encountered an obstruction while closing, only key/keypad and receiver will resume normal operation. 4. If the Loop Detector LED is on, reset the Loop Detector, verify correct wiring, set it to a different frequency, and/or change the sensitivity of the Loop Detector. 5. Ensure switch #8 is functioning. The 'Close Timer' (switch #4) must be set to the 'on' position.
How to fix an Eagle Gate Opener that will not open?
If your Eagle Gate Opener isn't opening, consider these potential causes: * A motor overload could be the issue. Reset the thermal breaker on the motor. * If the Radio Receiver isn't 'on' when the remote control is activated, the receiver in the gate operator may have malfunctioned in the 'off' position. * If the green LED is 'off,' turn 'on' the power switch and/or reset the main circuit breaker. * A blown fuse could also be the problem. Check and replace it with a proper fuse.
General| Type | Fish Finder |
|---|---|
| Operating Frequency | 200 kHz |
| Depth Range | Up to 600 feet |
| Display | LCD |
| Used on | Boats |
To Next Page
