Need help?Do you have a question about the Eagle Premier Series and is the answer not in the manual?
Details the function of each pushbutton (SET, ESC, UP, DWN, ADJ, ALM, CAL, ACK, CLEAR, x:y, ZRO, SPAN, PO1, 4mA, 20mA).
Explains how to set the decimal point for various probes (pH, ORP, FLR) using switch S2 on the RA-1000-CPU board.
Provides a step-by-step guide for basic probe calibration, focusing on residual probe setup with zero and span points.
Details how to calibrate pH, ORP, or Fluoride probes using points P1 and P2, and discusses specific considerations for Fluoride and Ammonia.
Explains how to calibrate the analog output channels (PO1/PO2) by setting 4mA and 20mA points for accurate current output.
To Next Page
General