Eagle Premier Series - ADVANCED PARAMETER MENU

ADVANCED PARAMETER MENU
To select the instrument as a meter (UPC1000), gas detector (GA-1000), meter, or
residual analyzer (RA-1000), do as follows: From the current main operating screen,
press SET and enter the password “1?1” and press the ENT pushbutton. Alternatively, if
one is in the setup menu, press the right most pushbutton until the password screen is
displayed, enter the password “1?1” and press the ENT pushbutton.
Parameter: MODE
Press the ADJ pushbutton to set the choice to METER (if not set).
Parameter: TEMPERATURE
Selects the unit of the temperature display as either degrees Celsius or Fahrenheit.
Parameter: BUZZER
Enables (ON) or disables (OFF) the audible alarm.
Parameters: K1, K2, K3
Sets the operating mode of the selected relay.
K1-K4 ENERGIZED DE-ENERGIZED
OFF
NEVER ALWAYS
LOW
INPUT <=
SP
INPUT > SP
LOW /w
ACK
INPUT <=
SP
INPUT > SP OR Acknowledged by USER
HIGH
INPUT >=
SP
INPUT < SP
HIGH /w
ACK
INPUT >=
SP
INPUT < SP OR Acknowledged by USER
After one is finished, press the ESC pushbutton to return to the main operating screen.
K1 – K3 are used for pH, fluoride, NH3, or ORP set points.
4