EasyManua.ls Logo

Eaglemaster LT-6200 - Sub-Function Setting

Default Icon
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Hi-tech hopping
code system
Press Button once Arm / Door Lock
Hold Button for 2 seconds Arm Without Siren/HornChirp
Press Button once after 10sec.armed Car finder
Press Button once after set Arming 1st stage- Sensors by Pass
Press Button twice after set Arming Sensors by Pass
Press Button Disarm / Doors unlock
Hold Button for 2 seconds. Disarm Without Siren/HornChirp
Press Both buttons once Panic / Anti Car-Jack (ACC ON)
Hold Both buttons for 2 seconds Trunk Opener
2nd stage-
REMOTE FUNCTION TABLE
Remote Features:
Each alarm is assorted with two special transmitters.
Hi-tech hopping code system is applied to each
transmitter. This system has supper confidential
technology. It can hardly possible be copied. It is used
high stable UHF frequency as radio transmission circuit.
For your operation convenience, four transmitters can
be learn into this alarm at the same time.
Transmitter's battery use: 12V GP23A
Sub-Function Setting
In Disarm position. Turn off IGN ,within 10 seconds press valet SW 5 times, until siren /horn
chirp 4 times and lights ON means system entering in programmable mode. The times of valet SW
pressing is according to the function item number. To judge it as per LED indication (times of
flashes).E.g. to set sub-function item No.2 :Press valet SW 2 times,LED quick flash 2 times after
a pause. Then press remote to select ON or OFF .To press button function will be ON , siren/horn
will giving two chirps. To press button function will be OFF ,siren/horn will giving four chirps.
Note: * means factory setting before delivery.
If the above condition happens , alarm will exit this setting mode by turn IGN to ON position or
within 10 seconds there is no setting activity , Lights will OFF.
SUB-FUNCTION TABLE
Item No. Function ON OFF
1 Immobilizer (smart engine disable) YES *NO
2 Passive arming function setting (door lock) YES *NO
3 Passive arming function setting (door without lock) YES *NO
4 Door switch arming detection delay *0sec. 45sec.
5 Safety Door Lock *YES NO
6 Unlock output 1or 2 pulse selection *1pulse 2pulse
7 Siren / Horn Selection *Siren Horn
8 Anti car-jacking mode selection *Active Passive
WARNING!
CHANGE BATTERY WHEN REMOTE
RANGE IS GETTING SHORT
Left button
Arm
Right button
Disarm

Related product manuals