Model Number
Purchase
Date
Purchase
Location
1. Reconnect Fan properly
2. When the fan is on turn the blades
slowly by hand
3. Replace Fan
1. The Temperature overloads
have tripped or the steam generator
is broken
1. Reset the Temperature overload pins
2. Replace steam generator
1. Replace Diverter Valve
1. Check the inlet water Pressure
2. Clean the filter at water inlet
1. Low inlet water pressure
2. Blockage in water inlet
Water Diverter
Valve can’ t divert
Water
1. There is no power to the unit
or the wires are not connected properly
2. The power is not switched on
3. The Connection wire for the control
panel is loose.
1. Turn on the power, Connect power wires
properly.
2. Switch on the power
3.Remove the wires and install again
ensuring proper connection.
1. Check Connections
2. Replace Light
No Display on
the Control
Panel?
There is Steam
Display on the
Control Panel
but not steam
comes out
Fan Does not
Work
1. The connecting wire is damaged
or loose.
2. Light is broken or damaged
To Previous Page
Loading...