To Next Page

To Previous Page

ARDISAM

TROUBLESHOOTING AND REPAIR

PROBLEM REMEDY/ACTION

Belts squeal in neutral and/or reverse

Belts squeal in forward operation

Excessive heat build up in transmission/tine area

during tilling

• Adjust forward belt guide:

- turn engine off and allow muffler to cool

- disconnect spark plug wire and secure from spark plug

- remove belt guard

- pull down on drive safety control levers

- manually bend forward belt guide so there is 1/16 inch

or less clearance between belt guide and belt

- replace belt guard and spark plug wire

• Adjust tabs on the reverse belt guide

- turn engine off and allow muffler to cool

- disconnect spark plug wire and secure from spark plug

- release drive safety control levers to neutral

- remove belt guard

- adjust tabs of reverse belt guide:

while drive safety control levers are released, bend

metal tabs on reverse belt guide to 1/64 inch or less

clearance from reverse belt

- replace belt guard and spark plug wire

• Remove vegetation by following instructions in Clean

Tine Axle Shaft of Normal Care section.

FOLLOW ALL SAFETY INSTRUCTIONS

• Check transmission fluid and fill if needed

EarthQuake CRT series User Manual

Questions and Answers: