EasyManuals Logo

EarthQuake MC440 User Manual

EarthQuake MC440
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Operator's Manual
MC440 4-Cycle Cultivator
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
10
OPERATION
PREPARING ENGINE FOR STARTING
GAS AND OIL
NOTE:
Engine is shipped from factory without oil. You must add
engine oil before starting engine. If engine is started without oil,
engine may be damaged beyond repair and will not be covered
by warranty.
Quality
To operate the engine, we recommend using VIPER brand
4-cycle oil (13235), included with each new MC440, or an equiv-
alent SAE 30 engine oil to ensure that the engine operates cor-
rectly throughout the life of the engine. Use straight unleaded
premium gasoline, low/no ethanol blends recommended.
Filling Fuel Tank
1. Shut-o engine and allow engine to completely cool before
relling the fuel tank.
2. Move to a well ventilated area, outdoors, away from ames
and sparks.
3. Clean debris from area around the fuel cap.
4. Loosen fuel cap slowly. Prevent the cap from coming in
contact with dirt or debris.
5. Carefully add fuel without spilling.
6. Do not ll gas tank completely full, allow space for fuel to
expand.
7. Immediately replace fuel cap and tighten. Wipe o spilled
fuel and allow to dry before starting engine.
Checking and Adding Oil
Be sure the engine is located on a level surface before checking or
relling oil. Proper position for checking oil level or relling oil is
face down, with the gas tank of the MC440 down on a horizontal
surface. SEE FIGURE 3
1. Clean around oil ll area.
2. Unscrew dipstick and wipe clean with cloth.
3. Reinsert dipstick (must be fully threaded for accurate reading).
4. Unscrew and check dipstick. If no oil shows on the dipstick,
rell to the top thread of the oil ll hole.
5. Change oil if contaminated.
CAUTION
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU
MUST ADD ENGINE OIL BEFORE STARTING ENGINE.
IF ENGINE IS STARTED WITHOUT OIL, ENGINE MAY BE
DAMAGED BEYOND REPAIR AND WILL NOT BE COVERED
BY WARRANTY.
NEVER STORE ENGINE WITH FUEL IN THE TANK INDOORS.
FUEL AND FUEL VAPORS ARE HIGHLY FLAMMABLE.
AN ADULT ONLY MUST ALWAYS HANDLE AND FILL
THE ENGINE WITH FUEL.
ALWAYS HANDLE GAS IN A WELL VENTILATED AREA,
OUTDOORS, AWAY FROM FLAMES OR SPARKS.
DO NOT START ENGINE IF FUEL IS SPILLED. WIPE OFF
EXCESS FUEL AND ALLOW TO DRY. REMOVE ENGINE
FROM AREA TO AVOID SPARKS.
IMPORTANT
DO NOT SPRAY WATER ON OR NEAR THE ELECTRON
ICS OF THE CULTIVATOR AS THIS MAY RESULT IN DAM
AGE TO THE ELECTRICAL COMPONENTS.
oil dipstick
FIGURE 3
oil drain
screw
MC440 Tipped Forward on Level, Horizontal Surface
OPERATION TIPS
1. The clutch will transfer maximum power after about two
hours of normal operation. During this break-in period clutch
slippage may occur. The clutch should be kept free of oil and
other moisture for ecient operation.
2. Cultivate without placing excessive body weight on the unit.
The MC440 operates most eciently with the weight of the
unit itself.
3. Never run engine indoors. Exhaust fumes are deadly.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EarthQuake MC440 and is the answer not in the manual?

EarthQuake MC440 Specifications

General IconGeneral
BrandEarthQuake
ModelMC440
CategoryTiller
LanguageEnglish

Related product manuals