<<< Flexi-Switching >>>
This device features Flexi-Switch
™
Technology! This relay-based, true bypass switching style
allows you to simultaneously use momentary and latching-style switching.
• For standard latching operation, tap the footswitch once to activate the effect and then tap
again to bypass.
• For momentary operation, hold the footswitch down for as long as you’d like to use the effect.
Once you release the switch, the effect will be bypassed.
Since the switching is relay-based, it requires power to pass signal.
OPERATION MANUAL
©2018 EarthQuaker Devices LLC
www.earthquakerdevices.com
<<< Pro Tip >>>
When using any of the envelope modes, we recommend placing the Aqueduct rst in the signal
chain and/or before any effects that increase volume or gain. The Aqueduct was designed for
low-to-medium output pickups. Any increase in output will make the envelope settings more
responsive at lower settings, thus making them less dynamic.
<<< Power Requirements >>>
<<< Tech Specs >>>
• Current Draw: 68mA
• This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We
always recommend pedal-specic, transformer-isolated wall-wart power supplies or multiple
isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power.
Switching-type power supplies, daisy chains and non-pedal specic power supplies do not lter
dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!
• Input Impedance: 1M Ohm • Output Impedance: <10K Ohm
<<< Warranty >>>
This device has a limited lifetime warranty. If it breaks, we will x it. Should you encounter any
issues, please email info@earthquakerdevices.com.
To Next Page
Need help?
General
