EasyManua.ls Logo

Easee Base - Safety Instructions; Installation Safety Guidelines; Operation Safety Guidelines

Easee Base
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
This product shall only be installed, repaired or serviced
by an authorised electrician. All applicable local, regional
and national regulations for electrical installations must be
respected.
Danger to life due to high electrical voltage. Never make any
changes to components or connecting cables.
The installation must not be carried out in the vicinity of
flammable, explosive media, flood areas (underground car
park) or areas where there is a danger of flowing water.
The product must be installed on a permanent location.
The terminals in the Backplate are energised when the
power circuit is closed and must never be in direct contact or
in contact with anything other than the plug-in electronics
(Chargeberry).
Depending on the type of installation, official authorisations
may be required prior to installation.
Danger to life due to high electrical voltage. Never make any
changes to components or connecting cables.
Always have the prescribed maintenance, installation and
any repair work carried out by an authorised electrician.
Never extinguish the product with water. Never clean it with
running water.
Do not immerse the product in water or other liquids.
Safety instructions for
the installation
Safety
instructions
Read the entire manual carefully before installing and
operating the product. Observe the following instructions:
Safety instructions for
operation