EW-5010A OPERATION MANUAL
1.2 Manual control Introduction
1-2-1. Enter this interface: main screen → manual control.
1-2-2. 9 green buttons are jog self-locking switches, which need to be
jogged again to unlock; the initial state when OFF, and the output state
when ON; pay attention to safety during this operation to ensure
yourself and surrounding personnel Safe, especially during two
operations.
1-2-3.The "peeling and backing" cylinder has a safety operation
detection. For example, when the "penetration terminal" is already in
the operating state, the "peeling and backing" button will be locked.
Clicking is invalid.
1-2-4. The “Manual Trigger” button is in the automatic mode. You can
press and hold to start the automatic operation for a period (press and
hold time is related to the value in the parameter setting), which is
To Next Page
Loading...