EASTONTECH EW-5010A - Change Product Adjustment; Vibration Plate Feed Adjustment

EW-5010A OPERATION MANUAL
14
ⅡChange product adjustment
2.1 Vibration plate feed adjustment
(Figure 212) (Figure 213) (Figure 214)
2-1-1. Figure 211 are the names of the parts supplied by the vibrating
plate.
2-1-2. Figure 212 shows the controller of the vibrating disk. This screen
shows the voltage H100. When the feeding speed of the various
terminals is too fast or too slow, you can press the up and down buttons
to adjust the voltage to the proper value. Usually, the terminal is first put.