EW-5010A OPERATION MANUAL
Observe whether to adjust.
2-1-3. Figure 213 This screen is displayed as frequency E50; only
frequency E50 and E100 are selected. A frequency E50 has been selected
when the machine leaves the factory, so no adjustment is required when
changing terminals (except for special cases).
2-1-4. Figure 214 is the amplifier with or without terminal induction; the
green number is the set value (default 500), the red number is the
current value; the red dot to the left of the green number is red when a
terminal is detected, no The terminal is off; there are buttons on the
right side of the red number, and the two rightmost up and down
buttons are for setting value adjustment.
(Figure 215) (Figure 216)
2-1-5. First confirm the terminal specifications that need to be changed,
and confirm whether to adjust the discharge guide 1 and the discharge
guide 2.
2-1-6. Adaptation of the discharge width of the discharge guide 1: 0.5,
0.75, 1.0 square can use 1.0 square as a reference for adjusting the width.
To Next Page
Loading...