EW-5010A OPERATION MANUAL
After 1.0 square is adjusted, 0.75 and 0.5 square can also be used;
1.5 and 2.5 squares can use 2.5 squares as a reference for adjusting the
width. After adjusting 2.5 squares and using them, 1.5 and 2.5 squares
can also be used (the above general may be related to changes in the
size of each manufacturer's terminal specifications).
2-1-7. Discharging guide 1: For infinite adjustment, loosen 2 M4 bolts
and slide up and down to a suitable width (see Figure 215);
2-1-8. Discharging guide rail 2: As shown in Figure 216, there are three
clamping positions of the discharging rail 2, which can be adjusted by
loosening two M4 bolts; 0.5, 0.75, and 1.0 squares are the minimum
clamping positions, 1.5 and 2.5 square Is the middle card position, and
4.5 square is the maximum card position.
(Figure 217) (Figure 218)
2-1-9. Figure 217 shows the installation of the terminal guide. Pay
attention to the installation direction. The small sides of the small U port
To Next Page
Loading...