EW-5010A OPERATION MANUAL
1.3 Stripping Setting
1-3-1. Enter this interface: main screen → peeling settings.
1-3-2. There are a total of 6 wire number specifications for the peeling
setting. There is a corresponding settable value for each wire number.
Shallower.
1-3-3. There is a corresponding three stripping lengths for each wire
number stripping length. Click the A button as shown in the figure above.
Click once to switch to B, and then click to switch to C. Then click to
switch back to A
1-3-4. The larger the peeling length value, the longer the peeling length,
the smaller the value, the shorter the peeling length, and the unit of the
peeling length is mm.
1-3-5. When selecting the line number above and modifying the peeling
To Next Page
Loading...