EW-5010A OPERATION MANUAL
depth or length, all are modified. Click "Modify Confirmation" to adjust
the actual position. After clicking Modify Confirmation, this key will
prompt the progress, and the selection or value cannot be modified at
this time.
1-3-6. After the machine is installed, the stripping depth and
corresponding stripping length of each line can be adjusted according to
different wire numbers. For example, after the stripping knife is replaced,
the stripping depth may vary. The size of the variation depends on the
processing accuracy of the stripping knife and Every installation position.
1-3-7. Motor setting: pull down the menu key, refer to the interface
introduction for details.
1-3-8. Main screen: Return to the main interface.
To Next Page
Loading...