Transporting Your EasyFold PRO 2.0
To transport your EasyFold PRO 2.0, it is advised that you fold it up following the instructions below.
CAUTION! Never transport the power wheelchair in a tie up system (electric mode), as the
EasyFold PRO 2.0 is not compatible with them. Do not place the folded power wheelchair in the
front seat with the driver where it could move and slide.
WARNING! Never sit in the wheelchair and be transported in a moving vehicle.
1. Turn OFF the power from the controller.
2. Remove the seat cushion.
3. Press down on the top of the backrest and flip the back safety latch down to unlock the
frame.
4. Fold the wheelchair. Do this by grasping the backrest bar and pushing it forward, towards
the seat of the chair. Optionally you can grasp with your other hand, the seat and pull it toward the
backrest.
5. When folded, the cross-bar can be used to move the wheelchair easily.
To Next Page
Loading...
