EasyGate TERRIER Series - Motor Mounting and Fixing; Electrical Wiring Connection

D
MOTOR FIXING
Assemble the rear bracket and fix it on the pillar.
E
WIRE CONNECTION:
TERRIER SERIES SWING GATE OPENER USER MANUAL
4
Release the gate opener and place the pin into the fitting position no.1 and no. 2
Make sure the gate openers are mounted in horizontal position especially in those positions.
1) Gate in “CLOSE” position
2) Gate in “OPEN” position
3) Gate at “45。angle” position
Prior to weld the bracket on the gate leaf(if necessary), cover the gate opener to prevent
damages from sparks.
(1) Avoid tension in the cable during open and close phase.
(2) Always connect the grounding wire(GND)
no.1
A
B
no.2
White(+)
Yellow(-)
Yellow(-)
White(+)
Motor
Motor