FW Series – firmware upgrade guide v2.0
11
Kits version VS Firmware version
Every firmware comes with a new set of Sedona kits that matches it firmware.
It is very important that you make sure you install/run your apps with the latest and correct kits against it
firmware.
The Sedona kit version numbering is constructed in five (5) segments as follows;
Example: easyioFWxxx 1.0.45.yy.zz
Represents
the kit is only
applicable for
the EasyIO FW
Series
This is the firmware
version supported.
This number will be
incremented with each
firmware release.
Kit revision number
This number will be
incremented with each kit
enhancement/release.
The following example is intended to assist in understanding the new numbering scheme.
This example is for the kit “easyioFWBACnet 1.0.45.12.28”.
Segment 1 - “easyioFW”- identifies that the kit is for FG Series Controller use only
Segment 2 - “BACnet” – identifies that the kit is the BACnet Kit
Segment 3 - “1.0.45” –identifies the Sedona platform build number
Segment 4 - “.12” –identifies the Sedona firmware version number and therefore denotes the compatible
controller firmware build (or version) number. In this case the Sedona firmware version number is “12”
and therefore is only compatible with firmware build (or Firmware version number) b12 of the FW series
controller firmware.
Remember that the Controller Firmware Version and the Sedona Kit Version must match. In this
example the Controller Firmware Version (or Build) number must be build “12”.
Segment 5 – “.6” –identifies the kit revision number. In this case the revision number is revision 6.
Please note the importance of the difference between the firmware version number and the Sedona Kit
REVISION number.
The Controller Firmware VERSION/BUILD number must be the same as the Sedona Kit VERSION number.
To Next Page
Loading...
Need help?
General
