c) Adjust the screw nut at the bottom of the platform (as shown in the figure below ,loosen the nut,
the platform rises, tighten the nut, and the platform falls). Adjust the height of the platform
through the nut so that the gap between the nozzle and the platform is just one sheet of paper
thickness (about 0.1mm). When the paper is gently pulled, there is obvious friction
between the paper and the nozzle, the nozzle will not damage the paper.
Note: When adjusting the nut, do not press the platform with your hand to avoid affecting the
accuracy of leveling.
d) After the
point is adjusted, press the leveling buttons 2, and do the same steps above to
complete the leveling of the
position. After that, use the same method to continue to complete
the leveling of
points.
e) If there are still print problems, you can repeat the whole leveling work 1-2 times.
Leveling completed！
（2）Load Filament , feed
before feed, you need make sure there is at least 3cm
space between the nozzle and the platform(Press print
button hold for 3 seconds and release, the printer head
will raise 1cm each time),
●Straighten the front end of the filament about
2cm ,Insert filament into the insert tube until it can not
To Next Page
Loading...
