What to do if green button 8 flashes and alarm beeps continuously on Eaton UPS?
If the green button on your Eaton UPS flashes frequently and the alarm beeps continuously, it means the battery backup outlets are overloaded. To fix this, disconnect some of the equipment connected to the battery backup outlets.
General| Power Rating | 550 VA |
|---|---|
| Output Power | 330 W |
| Input Voltage | 230 V |
| Output Voltage | 230 V |
| Topology | Line-interactive |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Communication Ports | USB |
| Surge Protection | Yes |
| Typical Backup Time at Full Load | 5 minutes |
| Humidity | 0-95% non-condensing |
| Warranty | 2 years |
| Battery Type | Lead-acid |
| Outlets | IEC C13 |
| Waveform Type | Modified sine wave |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Safety Approvals | IEC 62040-1 |
To Next Page
