Power supply connection
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source
and the true electrical consumption of the total load.
Connect the UPS to the AC-power source with cable
through a wall outlet equipped with an earth connector,
using your equipment cord.
Disconnect the protected equipment, keep the power
cable
Connect IEC cable provided on protected equipment
side.
Connect IEC cable provided on UPS AC output side
Connect the power cable to AC input
Connect the power cable to wall outlet
Protected outlets / Backup & Protected outlets
Plug critical equipment (computer, monitor, modem, etc.) to the backup & protected outlets providing battery backup
power, taking care not to exceed the rated current indicated in amperes.
Equipment connected to these outlets is supplied as soon as the AC cord is plugged in. These are not affected by ON/OFF
button.
To Next Page
Loading...
