Step 2.
Remove concentric neutral wires or jacket
ote:N Care should be taken to not cut or score the
neutral conductors when cutting the cable jacket.
•
Measure 12.75" (324 mm) from end of cable. Refer to
Figure 15.
• For jacketed neutral cable, remove jacket to 12.75"
dimension.
• For unjacketed neutral cable, bind neutral wires using
three (3) wraps of tape at 12.75" dimension.
•
Pull back concentric neutral wires. Allow enough extra
concentric neutral wires to connect to ground after installation
and allow movement to insulated standoff bushing.
Step 3.
Remove insulation shield
•
Remove insulation shield 9.75" (248 mm) from end of
cable. Refer to Figure 16.
•
Do not cut or nick insulation.
Step 4.
Put tape marker in place
•
Measure 1" (25 mm) from end of insulation shield. (Refer
to Figure 16.)
•
Wrap two turns of tape to serve as marker for cable
adapter location.
Step 5.
Remove conductor insulation
ote:N Do not pencil cable.
•
Remove insulation exposing bare conductor to length of
4.38" (111 mm). Refer to Figure 17.
ote:N Do not unwind conductor strands.
Step 6.
Bevel insulation
•
Remove sharp edge of insulation by beveling at a 45°
angle for approximately .25" (6 mm). (Refer to Figure 18.)
Figure 17. Line illustration of bare conductor length.
4.38" ± .13"
(111 mm ± 3 mm)
Tape Marker
Bare Conductor
Insulation
Figure 18. Line illustration of insulation bevel.
Bevel
Insulation
.25"
(6 mm)
Figure 15. Line illustration of removing concentric
neutral wires.
Bushing
Cable
1.75" ± .25"
(44 mm ± 6 mm)
12.75" ± .25"
(324 mm ± 6 mm)
Concentric Neutral
Wires
Figure 16. Line illustration of cable stripback.
9.75"
(248 mm ± 3 mm)
1"
(25 mm)
Tape Marker
Insulation Shield
Insulation
8
600 A 15/25 kV class BOL-T connector assembly installation instructions for MN650005EN February 2015
To Next Page
Loading...
