What to do if my Eaton 9E-IN 3K XL UPS is overloaded?
If the Eaton UPS indicates an overload, examine the connected loads. Remove any non-critical devices to reduce the load. Also, inspect the remaining devices for any failures.
How to fix high inverter temperature on Eaton 9E-IN 3K XL UPS?
If your Eaton UPS is experiencing high inverter temperature, first, check the UPS ventilation to ensure it's not obstructed. Second, verify that the ambient temperature around the UPS is within the recommended range.
Why is the emergency supply period shorter than nominal value on my Eaton 9E-IN 3K XL?
If the emergency power period of your Eaton UPS is shorter than expected, the batteries may not be fully charged. Allow the batteries to charge fully. If the issue persists, the batteries might be defective, consider replacing them or consulting your dealer.
What does 'Battery Open' mean on my Eaton 9E-IN 3K XL UPS?
If your Eaton UPS shows 'Battery Open', perform a battery test to confirm the issue. Ensure the battery bank is correctly connected to the UPS and that the battery breaker is turned on.
What to do if my Eaton UPS shows an inverter short circuit?
If your Eaton UPS has an inverter short circuit, remove all connected loads and turn off the UPS. Check the UPS output and the loads for any short circuits. After ensuring the short circuit is removed and the UPS has no internal faults, turn it on again.
How to troubleshoot over temperature fault in Eaton 9E-IN 3K XL UPS?
If your Eaton UPS displays an over temperature fault, check the unit's ventilation and the ambient temperature to ensure proper cooling.
What does 'Site Fail' mean on Eaton UPS and how to fix it?
If your Eaton UPS indicates a site failure, it means the phase and neutral conductors at the input of the UPS system are reversed. To resolve this, rotate the mains power socket by 180° or correctly connect the UPS system.
How to fix no communication data on Eaton 9E-IN 3K XL?
If your Eaton UPS is not providing communication data, verify that the RS232 wire is correctly matched or try changing it. Also, check or replace the USB wire to ensure a proper connection.
Why does my Eaton UPS have no indication even when connected to mains?
If there is no indication or warning tone from your Eaton UPS, even when connected to the mains power supply, check the building wiring socket outlet to ensure there is input voltage. Also, check the breaker input cable to make sure the breaker is not open.
What causes 'Inner Ambient temperature high' on Eaton UPS?
If your Eaton UPS reports 'Inner Ambient temperature high', verify the environment has adequate ventilation.
General| Output Power | 2700 W |
|---|---|
| Form Factor | Tower |
| Operating Temperature | 0 to 40 °C |
| Power Rating | 3000 VA |
| Input Voltage | 230 V |
| Output Voltage | 200-240 VAC |
| Input Frequency | 45-65 Hz |
| Output Frequency | 50/60 Hz |
| Battery Type | Sealed Lead Acid |
| Communication Ports | USB, RS-232 |
| Extended Runtime | Yes |
| Topology | Double Conversion Online |
Guidelines for safe UPS installation and environmental considerations.
Key instructions for safe operation of the UPS unit.
Procedures for maintenance, servicing, and handling common faults.
Detailed functions of the control panel buttons for UPS operation.
Explanation of the LCD display elements, icons, and information.
Detailed steps for connecting the UPS input power and output sockets.
The process for recharging the UPS external batteries.
Step-by-step instructions for powering the UPS on and off.
To Next Page
