Eaton ATS 16 - Power cables connection; Installation diagram; Input;Output connection

Page 11
EATS16_EN
ENGLISH
3.5 Wall installation
Follow steps 1 to 2 for module mounting on the wall.
2
1
2
1
3.6 Instructions
1.ElevatedOperatingAmbient-Ifinstalledinaclosedormulti-unitrackassembly,theoperatingambient
temperatureoftherackenvironmentmaybegreaterthanroomambient.Therefore,consideration
shouldbegiventoinstallingtheequipmentinanenvironmentcompatiblewiththemaximumambient
temperature(Tmax)speciedbythemanufacturer.
2. ReducedAirFlow-Installationoftheequipmentinarackshouldbesuchthattheamountofairow
required for safe operation of the equipment is not compromised.
3. MechanicalLoading-Mountingoftheequipmentintherackshouldbesuchthatahazardousconditionis
not achieved due to uneven mechanical loading.
4. CircuitOverloading-Considerationshouldbegiventotheconnectionoftheequipmenttothesupply
circuit and the effect that overloading of the circuits might have on overcurrent protection and supply
wiring.Appropriateconsiderationofequipmentnameplateratingsshouldbeusedwhenaddressingthis
concern.
5.ReliableEarthing-Reliablegroundingofrack-mountedequipmentshouldbemaintained.Particular
attentionshouldbegiventosupplyconnectionsotherthandirectconnectionstothebranchcircuit(e.g.
use of power strips).
3. Installation for ATS