What to do if Eaton ATS 16 Switch shows an overload?
If your Eaton Switch is overloaded, it means the power requirement exceeds the ATS capacity (greater than 105% of nominal). To resolve this, remove some equipment from the ATS. The ATS will continue to operate but may shut down if the load increases further. The alarm resets when the condition becomes inactive.
What to do if Eaton ATS 16 Switch has a short-circuit fault?
If your Eaton Switch indicates a short-circuit fault, check the device connection or integrity. If the error persists, note the alarm message and the ATS serial number, and then contact your service representative.
Why Eaton ATS 16 has Source 1 or Source 2 power supply fault?
A Source 1 or Source 2 power supply fault in your Eaton Switch indicates that the internal power supply of one of the sources is faulty; the other source is powering the load. Note the alarm message and the ATS serial number, and then contact your service representative.
What to do if Eaton ATS 16 Switch shows an internal relay fault?
If your Eaton Switch displays an internal relay fault, note that the load is not powered. Note the alarm message and the ATS serial number, and then contact your service representative.
What to do if Eaton ATS 16 has EEPROM fault?
If your Eaton Switch is showing an EEPROM fault, note that the load is still powered. Note the alarm message and the ATS serial number, and then contact your service representative.
Lists safety, EMC, and performance standards.
General precautions for servicing and operating the unit.
Warnings about power cords, plugs, outlets, and load types.
Details physical size and weight of the ATS models.
Identifies connectors and ports on the rear panel.
Describes the buttons and display on the front panel for operation.
Explains the information displayed on the ATS LCD screen.
Describes configurable parameters and their options.
Lists potential events and their root causes and actions.
Lists items included in the accessory kit for installation.
Provides guidance on storing the ATS unit.
Instructions for mounting the ATS in a standard rack.
Instructions for mounting the ATS in a 2-post rack.
Instructions for mounting the ATS on a wall.
General instructions for installation considerations.
Illustrates the power connection setup.
Details how to connect input and output power cables.
Details the RS232 serial connection for communication.
Explains contact characteristics for optocoupler signals.
Information on network connectivity cards for the ATS.
Information about the software for managing the ATS.
Guide to diagnosing and resolving common issues.
Lists ATS models with operating voltage, current, and frequency.
Details physical size and weight of the ATS models.
Specifies the input connection type for the ATS.
Specifies the output connection types for the ATS.
Details operating temperature, humidity, and altitude limits.
General| Type | Automatic Transfer Switch |
|---|---|
| Current Rating | 16A |
| Voltage | 230V |
| Frequency | 50/60Hz |
| Number of Phases | 1 |
| Output Current | 16A |
| Form Factor | 1U |
| Number of Poles | 2 |
| Number of Outlets | 8 |
| Input Connection | IEC C20 |
| Humidity | 95% RH non-condensing |
| Standards | IEC 62310 |
| Mounting Type | Rack-mountable |
| Operating Temperature | 0°C to 40°C |
To Next Page
