Eaton ATS 16 - SAFETY INSTRUCTIONS; Certification standards; Important safety notes; Electrical warnings

Page 2
EATS16_EN
SAVE THESE INSTRUCTIONS. This manual contains important instructions
that should be followed during installation and maintenance of the ATS.
The EATON ATS models that are covered in this manual are intended for installation
in an environment within 0°C to 40°C (32°F to 104°F) and free of conductive contaminant.
Certication standards
• Safety:IEC62310-1
• EMC:IEC62310-2
• Performance:IEC62310-3
• CEMark
• Additionalconformances:
- IEC60950-1
- CISPR22ClassB
Important safety notes
• Onlyqualiedpersonnelcanservicethisequipment.
• Followthefollowingprecautionswhenworkingonthisunit.
- Removewatches,rings,orothermetalobjects.
- Usetoolswithinsulatedhandles.
• Examinethepackingcontainer.Notifythecarrierimmediatelyifanydamageispresent.
• Donotdisassembletheunit.
• Do not operate the unit near water or in an area with excessive humidity.
• Keepliquidandforeignobjectsfromgettinginsidetheunit.
• Donotoperatetheunitclosetogasorre.
• Verifywhetherthebranchcircuitbreakerorfuseonservicefeediscorrect.
• Verify line voltage requirements and the supplied line voltage prior to installation.
• Thisunitissuppliedfrommultiplesources,disconnectallsourcesbeforeservicing.
Electrical warnings
• Checkthatpowercords,plugs,andoutletsareingoodcondition.
• RAL equipment:"EquipmentintendedforinstallationinRestrictedAccessLocation".
Warning
• Intendedtobeconnectedtocomputerload.
• Nottobeconnectedtoinductiveloadorwith>3:1crestfactorload.
SAFETY INSTRUCTIONS