Eaton Bussmann Series - Introduction to the PV Combiner Box

2
Installation manual 3A3718 Rev E
Effective February 2019
CCP2-H4X-_ pistol handles for 12 mm shafts
Eaton.com/bussmannseries
Switch and switch handle applications
Complete handle installation requires installing a switch, rotary mechanism (front or side) and shaft (purchased separately).
Please review the chart below to ensure you have the right switch, rotary mechanism and shaft for your application.
Note: Front rotary mechanism can only be installed on three-pole switches.
CCP2 catalog no.
Front rotary
mechanism
Right/left
side rotary
mechanism
Front/right side
clockwise handles
Left side
counterclockwise handles
Uses either
shaft size
CCP2-(poles)-200CF
CCP2-RM2*
CCP2-SM
CCP2-H4X-B3 (short - black/grey)
CCP2-H4X-R3 (short - red/yellow)
CCP2-H4X-B4 (long - black/grey)
CCP2-H4X-R4 (long - red/yellow)
CCP2-H4X-B3L (short - black/grey)
CCP2-H4X-R3L (short - red/yellow)
CCP2-H4X-B4L (long - black/grey)
CCP2-H4X-R4L (long - red/yellow)
CCP2-SH2-225
(8.9”/225 mm)
CCP2-SH2-425
(16.7”/425 mm)
CCD2-3-200
CCP2-(poles)-400CF
CCP2-RM4*
CCD2-3-400
* For three-pole switches only.
Required tools
•
Measuring tape/ruler
•
Pencil/felt tip pen
•
2 mm, 2.5 mm and 4 mm Allen wrenches
•
Z2/#2 Phillips head screwdriver
•
Straight blade screwdriver
•
Needle nose pliers
•
40 mm knockout punch or hole saw
•
8 mm drill bit for metal
•
Drill
•
Utility knife
•
Hacksaw
•
Metal file
•
Center punch
•
Hammer
Handle kit contents
Before proceeding, review the kit contents with the parts listed
below to be sure all necessary components are at hand. Contact
your supplier if any parts are missing.
(4) Backer plate
mounting screws
(1) Shaft
coupler
(1) Handle backer plate with
removable depth gauge and
shaft centering jig.
(1) Switch handle