Eaton Bussmann Series - Anatomy of the Combiner Box

4
Installation manual 3A3718 Rev E
Effective February 2019
CCP2-H4X-_ pistol handles for 12 mm shafts
Eaton.com/bussmannseries
Front clockwise handle
operation and installation
The following applies to all clockwise
operating handles.
Procedures for clockwise handle
catalog numbers:
•
CCP2-H4X-B3 (short)
•
CCP2-H4X-R3 (short)
•
CCP2-H4X-B4 (long)
•
CCP2-H4X-R4 (long)
For installation with switch catalog
numbers:
•
CCP2-(poles)-200CF
•
CCD2-3-200
•
CCP2-(poles)-400CF
•
CCD2-3-400
And requires installation of:
•
The front rotary mechanism:
• CCP2-RM2 (200 A case size)
• CCP2-RM4 (400 A case size)
•
Either shaft catalog numbers:
• CCP2-SH2-225
• CCP2-SH2-425
ON
OFF
ON
X
Handle interlock defeat operation
To be performed only by qualified personnel.
OFF
ON
OFF
X
X
X
Switch operating modes
ON
OFF
X
X
X
X
ON
ON
ON
OFF
OFF
OFF
X
2.5 mm Allen wrench
3 N•m (27 lb-in)
Break out this
portion of
the bezel
2.5 mm Allen wrench
Handle lock ON operation
Note: NOT to be utilized when switch is applied as a means for emergency stop.
To enable the handle’s lock ON feature:
•
Use a 2.5 mm Allen wrench to loosen the setscrew and remove the handle from the handle
base as shown.
•
Using needle nose pliers, break off the retaining stop on the switch handle bezel as shown.
•
Place handle back onto the handle base and tighten the setscrew to 3 N•m (27 lb-in).